| To: | vinsantis@sbcglobal.net, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] installing ladder line |
| From: | John Molenda <cdistflatfoot@gmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sun, 07 Nov 2010 15:38:17 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
And what can it not touch ? thanks John On 11/7/2010 3:36 PM, Vince Santis wrote: > Can 450 ohm ladder line be bent at 90 degrees around obstructions? > > Vince Santis, N1vs > > _______________________________________________ > TenTec mailing list > TenTec@contesting.com > http://lists.contesting.com/mailman/listinfo/tentec _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] installing ladder line, Vince Santis |
|---|---|
| Next by Date: | Re: [TenTec] installing ladder line, Rick - NJ0IP / DJ0IP |
| Previous by Thread: | [TenTec] installing ladder line, Vince Santis |
| Next by Thread: | Re: [TenTec] installing ladder line, Stuart Rohre |
| Indexes: | [Date] [Thread] [Top] [All Lists] |