| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] New Eagle vs. Used Omni VII |
| From: | Richards <jruing@ameritech.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 23 Dec 2010 14:03:39 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I did not see this answer when I posted my comment... ============================= JHR ========================= On 12/22/2010 1:01 PM, d.e.warnick@comcast.net wrote: > > > Yes, but that is for either a straight key or a keyer output. I want to use > the internal keyer and that is not supported on the rear. _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] New Eagle vs. Used Omni VII, Richards |
|---|---|
| Next by Date: | Re: [TenTec] New Eagle vs. Used Omni VII, Scott Harwood |
| Previous by Thread: | Re: [TenTec] New Eagle vs. Used Omni VII, d . e . warnick |
| Next by Thread: | Re: [TenTec] New Eagle vs. Used Omni VII, Richards |
| Indexes: | [Date] [Thread] [Top] [All Lists] |