do you have the baud set properly? the Orion runs at a very high baud
rate. don't know about the Pegasus.
jack
ak7o
On Sat, 2011-04-23 at 19:06 -0400, yash@aol.com wrote:
>
> Using the TT software from the TT down load site. Computer is xp with sp-3
> and 4 gig of ram. Software loads fine on computer. Using a usb to serial
> cable,which on the device controller says its in place and working fine and
> is set on com 3. I went into the TT software and changed from com1 to com3 .
> turned on the Pegasus and started the software the two could not communicate
> with each other. tried all 6 different com port settings ,nothing changes. re
> loaded the TT software ,no change. What about the Baud rate and priority
> stuff,make a difference? could find no where the TT requirements for rates
> etc.
> I just got this Pegasus, was told it worked fine ...don't they all say
> that... I will buy the N4PY software as soon as I make sure the basic Pegasus
> is working ok. But need to get it up and on line with what I have.
>
> Maybe the usb/serial cable a bad thing??
> can put a serial card in if needed .
>
> Sure would be grateful for any help on this. After using a flex 5000 and
> power sdr for 4 years,thought the little Pegasus would be a no brainier.
> Thanks
> dale wt4t
>
>
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|