[TenTec] paralleling power supplies to run Herc II

[Allan Taylor <k7gt.cw@gmail.com>]

Hi,

I finally picked up a 2nd 50A Astron power supply to make a pair. Are
there any issues in paralleling these to run the Herc II? I am going
to verify that the terminal voltage is identical within .01V. If this
is not OK, I can split up the conductors in the TT pigtail to power
two amp modules at a time from each 50A supply.

Thoughts??

-- 
73     Allan    K7GT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec