One more thing.......
Never use any outboard (DSP) processor for the audio. The greatest asset of the
ORION is its ability of a wonderfull recovered audio presentation.
Use your RF Gain, never set it above 90. Ever. Not even on 10/12mtrs.
So, .....actually two :)
73, Mark,PA5MW
On 9 nov. 2011, at 11:29, Dave G3RXP <g3rxp@btinternet.com> wrote:
> Hi Barry and Mark thanks for the info - I think the internal L/S is disabled
> when the external L/S is plugged in, the same with headphones - but Ill
> check those suggestions again.
> Just thinking about it I have my headphones connected to the back exp L/S
> via an external DSB audio filter so that may be the problem.
>
>
> Thanks Dave
>
> ----- Original Message -----
> From: "Barry N1EU" <barry.n1eu@gmail.com>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Wednesday, November 09, 2011 9:28 AM
> Subject: Re: [TenTec] Orion 2 query L/S on 2nd receiver.
>
>
>> On Wed, Nov 9, 2011 at 9:18 AM, Dave G3RXP <g3rxp@btinternet.com> wrote:
>>
>>> I would like to monitor the 2nd RX by loudspeaker and use the headphones
>>> for the main RX and wondered what is the best method to do this. I could
>>> use the line output socket at the back but I may have missed an easy
>>> option?
>>
>> Why not use the EXT SPKR output on the rear panel (or just the Orion's
>> internal speaker) with Audio configured as Left/Right=Main and
>> Spkr=Sub?
>>
>> Barry N1EU
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|