| To: | tentec@contesting.com |
|---|---|
| Subject: | [TenTec] OMNI D ser B low power output--still no joy |
| From: | scottsheppard@videotron.ca |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 11 Feb 2012 16:01:23 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
well, I have replaced all diodes save the zenor, the small signal transistors have also been replaced with 2n3904's and I have bypassed the PA all together...have virtually no output---maybe something in teh QRPp range...hardly moves needle at all on the SWR (Fwd) pos... I do note my 'T' voltage is only 9.4 as opposed to 10.4...my meter may be off a bit but thats over a volt...can the T voltage be adjusted? Sincerely appreciate all the input I have rec'd... scott _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Test Message, ARDUJENSKI |
|---|---|
| Next by Date: | [TenTec] RX366 IF output and roofing filters, Zivney, Terry |
| Previous by Thread: | [TenTec] Test Message, ARDUJENSKI |
| Next by Thread: | Re: [TenTec] OMNI D ser B low power output--still no joy, Mike Bryce |
| Indexes: | [Date] [Thread] [Top] [All Lists] |