Scott,
Thanks for the tip. What did you do, put a meter inline on the bias
source? Ahhh The old "RTFM" still works. Instructions are right in the
manual. Should I start by monitoring the driver bias and work forward or
go the other way?
John / WA1JG
On 2/16/2012 12:48 PM, scottsheppard@videotron.ca wrote:
> I had the same problem with mine...I had to play with the final bias as it
> was not sufficient and going into class C I believe...As I recall the curent
> reading ended up being bit higher than called for in the manual, but it was
> nice a clear after that... scott VA3IED
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|