| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] OMNI C Mixer or PTO problem |
| From: | Michael Silevitch <msilevitch@coe.neu.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 20 Feb 2012 15:44:00 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I adjusted that pot with no change on the display. It looks like there is
no PTO output. I'll get a counter tomorrow and look with that.
Regards
Mike
On 2/20/12 2:25 PM, "Scott Sheppard" <scottsheppard@videotron.ca> wrote:
>Yes, thats the one...you should then see it go back on freq and not just
>reading the counter presets...I am at the rig now and just confirmed...
>
>scott va3ied
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] OT: O'scopes, Stuart Rohre |
|---|---|
| Next by Date: | Re: [TenTec] OMNI C Mixer or PTO problem, Michael Silevitch |
| Previous by Thread: | [TenTec] OMNI C Mixer or PTO problem, Scott Sheppard |
| Next by Thread: | [TenTec] OMNI C Mixer or PTO problem, scottsheppard |
| Indexes: | [Date] [Thread] [Top] [All Lists] |