I will let the more qualified guys answer the question better, but:
        1)  Congratulations - nice birthday present.
        2)  Check the Jupiter manual.   Typically, it only needs an key
                line to key the amp.
        3)   Check the Jupiter manual... it might have a "TX/RX Delay"
                setting you can use for matching rig to amp.
                        "Timing is the Essence of Good Comedy..."
                Page 3-5 of the Jupiter user manual call this
                Transmitter-to- Receiver "hang time"   to guard
                against hot switching   the rig-amp combination.
                You need to consult the amp instruction manual
                for any information it might have on how long to
                delay it... but usually not much time is necessary - in
                the absence of any specific number, I would pick
                something in the moderate range, maybe 30 percent
                of the maximum time as a starting point.
                This is the way I hook up my Omni VII to the Alpha
                amps we use at a contest station I sometimes play at.
                I just need a key line and the RF, with suitable delay
                or what is called "hang time" in the Jupiter manual.
        4)      Page 3-5 of the user manual addresses external amp
                connections.
        5)  Figure 3-1 on Page 3-6 shows  connections and patch
                cabling for  a)  RF output/RF Input  and  b) Key Line
                to key the amp.
                
Looking at the user manual PDF file... it appears to be one I made for
TenTec a couple of years back as a favor for Scott when he was
still there ...  they really should update and reprint it...
        Happy trails.  Just My take, but I think this is all
        ya need.   Others more qualified can tell ya better.
===============  K8JHR  =======================
        
On 5/27/2012 7:45 PM, john brown wrote:
>
> Hi , Everyone 1st time using the list. I have just received from my wife, an 
> ALS 600 amp (HAPPY BIRTHDAY) and am looking for info, on how to set it up 
> with my Jupiter. I know Ameritron sells a ARB Relay Interface, but they do 
> not list a cable for Ten Tec. Is the interface necessary? Do I need to make 
> up a cable? If I recall correctly, the Jupiter does not have an external ALC 
> output. Any help would be greatly appreciated. TNX John Brown, N2YDF .        
>    E mail / N2YDF at Hotmail.Com                                     
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
 |