In a message dated 12/10/2012 4:35:50 PM GMT Standard Time,
k2ep@nycap.rr.com writes:
>
> I am trying to use my O2 on fsk. Unfortunately the manual gives very
> little info. on this mode. When receiving in fsk mode I must adjust my pbt
> to
> about -1800 to get readable signal. It decodes fine then. Is this normal?
> Is there some where I can get more info. on operating fsk? The keying
> sound ok on the monitor. Mark is set low. Are their any other setting I
Ernie,
Rightly or wrongly, I have Mark set to High and PBT to zero. In MMTTY,
Mark is 2125 and Shift is 170. Tx Port under Misc is set to Com-TxD(FSK)..
All I know is that it works.
73 Ray W2RS
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|