| To: | <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] RX-366 doesn't work with 3.033XA |
| From: | "Joerg Vollbrecht" <dl4cf@gmx.de> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 22 Dec 2012 06:03:24 +0100 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Hello, I was just trying to get my Orion II updated with the latest firmware (Ver3.033xa). Everything worked fine except for the RX-366 sub-RX. It did not come alive at all. Not even after a Master reset! It just kept silent. Finally I went back to version 3.029 and the RX-366 is working again without any problems. Any idea? 73 Joe, DL4CF Joerg Vollbrecht Steingasse 3 06642 Nebra (Unstrut) _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] 526 V/UHF WTB, Michael Tortorella |
|---|---|
| Next by Date: | Re: [TenTec] Omni VI Plus, Richards |
| Previous by Thread: | [TenTec] 526 V/UHF WTB, Michael Tortorella |
| Next by Thread: | [TenTec] WTB: Omni V, Jim Stoneback |
| Indexes: | [Date] [Thread] [Top] [All Lists] |