[TenTec] Corsair II Display Segments

["Adrian Rees (MW1LCR)" <mw1lcr@elsasystems.co.uk>]

Hi all
I have just acquired a Corsair II, and am very impressed with it so, 
far. However, in two of the 7 segment displays, the LED's are not 
lighting. If you think about the digits 2 and 3, its the bottom segment 
in each of them, and in the Tens and Units of MHz.
I am guessing the problem will be either a dodgy connection, or similar 
dry joint type of affair. The previous owner has replaced a number of 
electrolytic capacitors in the display, FWIW.
Apart from the dodgy connection / dry joint is there anything else I 
should consider ?

Cheers

Adrian MW1LCR / GW9X
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec