Looked at schematic for audio processor and u2a only has pin 1-4,however there
is a 15k between pin 1 and 2 of u2a. The chip info in my manual shows a dot to
indicate pin 1.
1> 8 > is dot. Is this the right one?
2 7
3 6
4 5
de nf4r
----- Original Message -----
From: "Phil Chambley, Sr." <k4dpk@comcast.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, March 25, 2013 1:35:58 PM
Subject: Re: [TenTec] Need help with corsair ii
*I think R68, at 15k ohms, is holding the first mic amp gain down n the
Corsair.
If I recall correctly, I have in the past changed this resistor to*
*around 220k-330k to bring the gain up. The Paragon has a 470k in that
position.
In the Corsair, that resistor is between pins 6 and 7 of U2A
*
> **
*Phil C. Sr.
k4dpk*
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|