Cool, Jerry, I am not that handy as to fit it all in like that.
Do you have any drawings, photos, schematics you could share with me?
I would love to see other ways of skinning the cat.
----------------------- K8JHR ---------------------------------
On 3/28/2013 2:03 PM, Jerry Haigwood wrote:
For my TS-590S, I built everything inside of the 8 pin mic plug. I used two
tantalum caps and two 1/8 watt resistors and removed the pins of the mic
plug which were not used to allow a little extra room. I brought out a
3.5mm jack for the headset mic and I purchased a 3.5mm to 1/4 inch adapter
for the headphones. I also brought out a 2.5mm jack for the PTT. I use
either foot switch or a hand switch made out of PVC tubing and end caps. A
small PTT switch is mounted in the PVC cap. I documented all this and put it
up on the Kenwood TS-590S email list. The same method can be used for the O
II. The headset came from Walmart and is labeled as a GE product.
______________________________________________________________
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|