Thanks
On Aug 3, 2013, at 2:04 PM, Steve Hunt wrote:
> Run any FF 3D plot and look at the Average Gain figure; it will tell you what
> fraction of the total input power is reaching the Far Field. If you set the
> wire losses to zero, you'll be left with just ground losses. AG is an
> efficiency figure, so 1-AG is the loss figure.
>
> Steve G3TXQ
>
>
>
>
>
> On 03/08/2013 21:51, k6jek wrote:
>> Steve,
>>
>> Where are you getting losses out of EZNEC? I did re-run the the dipole at 25
>> and 55. As expected, all sorts of things are different. But where are you
>> reading losses?
>>
>> Jon
>>
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|