Re: [TenTec] Herc 2 LP Cap?

[John Huffman <hjohnc@gmail.com>]

Phil -

It's the big yellow one in the 20 meter LPF.  If you look at the board 
from the ten meter LPF end, it's the one on the left on the 20 meter 
LPF.  There is a small blue one to the left of it and the coil to the 
right of it.
73 de K1ESE
John


On 8/26/2013 9:10 PM, Phil Chambley, Sr. wrote:
> John
>
>
> As it happens, I have a Herc II opened up on the work bench.  If you 
> tell me which LPF is involved (what band?), I'll see if I can give you 
> some guidance.
> Phil C. Sr.
> k4dpk
>
>
>
> On 8/26/2013 7:27 PM, george fritkin wrote:
> > Schematics do not give a parts description and do not use what you 
> > took out, maybe someone replaced the original with the wrong 
> > component.  Go to parts list in manual and if not listed call TT.
> >   George, W6GF
> >
> > ________________________________
> >   From: John Huffman <hjohnc@gmail.com>
> > To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> > Sent: Monday, August 26, 2013 1:03 PM
> > Subject: [TenTec] Herc 2 LP Cap?
> >
> > I burned up a capacitor in the low pass filter of my Hercules 2 
> > amplifier.
> > According to the schematic it is C42 with a value of "100".
> >
> > I'd like to replace it.  Is "100" the value on the schematic in PF? It's
> > a big yellow disk.  What voltage cap should I buy?
> >
> > 73 de K1ESE
> > John
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec