Thanks , I just don't remember using anything else but the serial port for the
logging
73 john
ps where does that get connected in the rear of the omni
________________________________
From: Barry N1EU <barry.n1eu@gmail.com>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Wednesday, October 2, 2013 6:05 AM
Subject: Re: [TenTec] omni 6
You need a keying interface between the computer and Omni that will
drive the key input of the Omni. This is typically done with a COM
(or LPT) device or a WinKey keyer.
73, Barry N1EU
On Wed, Oct 2, 2013 at 9:58 AM, JOHN <ku3g@yahoo.com> wrote:
> Good . morning ,just got a used Omni 6 and am running n3fjp software.After
> some intial problems the logging and spotting work great but I am having some
> difficulty setting up the keying using the external keyboard and the
> computer. I had an Omni before and recall or I think I do that there was no
> other connection from the computer
> to the rig , any help would be appreciated
> 73
> John KU3G
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|