| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Omni C + new Ham = Oops. |
| From: | Richards <jrichards@k8jhr.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 16 Oct 2013 20:13:53 -0400 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
All good tips amounting to Axioms ... although you left out the most important one, i.e., one must remember which end is the handle. ;-) --------------------- K8JHR ------------------ On 10/16/2013 8:04 PM, chacuff@cableone.net wrote: Well as far as soldering there are a bunch more.... ______________________________________________ _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| Previous by Date: | Re: [TenTec] Omni C + new Ham = Oops., chacuff |
|---|---|
| Next by Date: | Re: [TenTec] Omni C + new Ham = Oops., frank holladay |
| Previous by Thread: | Re: [TenTec] Omni C + new Ham = Oops., chacuff |
| Next by Thread: | Re: [TenTec] Omni C + new Ham = Oops., frank holladay |
| Indexes: | [Date] [Thread] [Top] [All Lists] |