TenTec
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [TenTec] Failure Modes for 811a tubes? Centaur

from [Steve Berg] [Permanent Link][Original]
To: tentec@contesting.com
Subject: Re: [TenTec] Failure Modes for 811a tubes? Centaur
From: Steve Berg <wa9jml@frontier.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 17 Oct 2013 20:12:20 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com> 
I run the amp on its own 220 volt circuit.

73,

Steve WA9JML
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: [TenTec] Failure Modes for 811a tubes?, Bob McGraw - K4TAX
Next by Date:  Re: [TenTec] Failure Modes for 811a tubes? Centaur, Bob McGraw - K4TAX
Previous by Thread:  Re: [TenTec] Failure Modes for 811a tubes? Centaur, Steve Berg
Next by Thread:  Re: [TenTec] Failure Modes for 811a tubes? Centaur, Bob McGraw - K4TAX
Indexes:  [Date] [Thread] [Top] [All Lists]