I am wanting to calibrate the BFO oscillators per page 4-43 of the manual. I
cannot get my frequency counter probe into the small RG-174 jack at Connector
46 of the TX audio board. So, I suppose I need to rig up a test lead that will
plug in at Connector 46.
Does anyone have a supplier/part number for the male RG-174 plug that attaches
at Connector 46? Or, even better yet, for about a one foot run of coax with
that plug on one end and a BNC connector on the other end?
Thanks for any advice you might be able to provide. 73.
--
Reed L. Christiansen, WI9P
Email: reed@wi9p.com
http://www.wi9p.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|