Hi Bob,
 I don't find the airplane comparison to be reasonable. In my example the 
penalty for choosing the wrong power supply from a very limited choice, 
with little information about the performance of the available choices, 
is a week at the cabin without being able to hear weak signals on your 
radio. In your example the penalty of piloting an unsafe aircraft could 
be death.
 I devised a hypothetical situation in which a person has limited time, 
information and resources to select a power supply. I think anyone in 
this situation who is experienced with HF radio and DC power supplies of 
both the linear  and switched mode varieties would chose the linear mode 
supply. Even those of us who know that "properly engineered" switched 
mode power supplies do exist, are aware that the chances of getting RF 
noise from a switched mode power supply are much greater than from a 
linear mode one.
DE N6KB
On 1/20/2014 5:21 PM, Bob McGraw - K4TAX wrote:
 I would never pilot an airplane unless I performed a proper and 
complete ground inspection while using a check-list.
 I would never buy a power supply unless I perfromed a proper 
evaluation but first knowing the needed power requirements.
73
Bob, K4TAX
 ----- Original Message ----- From: "Ken Brown" 
<ken.d.brown@hawaiiantel.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, January 20, 2014 8:19 PM
Subject: Re: [TenTec] Power supply types
 They are both commonly available and they can both be used to power 
typical HF transceivers. I think it is a reasonable comparison to make.
 Here is another question: What kind of power supply did you first see 
reviews in QST in which the subject of RF noise generation was even 
mentioned?
 Yes, switched mode power supplies CAN be made that do not generate 
(and radiate) RF noise. And switched mode power supplies are 
generally more energy efficient.:
How about we state the question this way:
 Suppose you're on vacation and you brought your mobile rig along with 
you, which runs on 12 VDC. You planned on only operating from your 
vehicle, so you did not bring a power supply for use from 120 VAC. 
You are offered an opportunity to stay for free in a nice vacation 
rental cabin for a week. The cabin has all the conveniences, 
including grid power. There are tall trees and you have a spool of 
skinny copper wire and an antenna tuner in your vehicle. You think it 
will be a great opportunity to get on the air from a remote location, 
with hopefully not a lot of RF noise. Before you head up into the 
mountains to the go to the cabin you see a store which sells two 
kinds of power supplies that have the right voltage and current 
rating to power your rig. One of the power supplies is very 
lightweight and the label say it is super efficient and uses 
switching mode technology. The other power supply is heavier, and you 
can see it has a laminated iron core transformer and a big 
electrolytic capacitor in it. The prices of the two power supplies 
are identical and they both appear to be well constructed. You cannot 
find any other data about these power supplies. The drive to the 
cabin is long, and you don't intend to drive back to town until you 
have finished your stay at the cabin. If you buy both power supplies, 
you won't have enough money left to buy the wrist rocket slingshot 
you intend to use to send the skinny wire up into the tall trees.
Which power supply would you buy?
DE N6KB
On 1/20/2014 3:41 PM, Kim Elmore wrote:
 
This is an apples vs pecans question.
Better-stated questions:
 What's the probability that a properly-designed and engineered 
linear power supply will radiate  RF noise of sufficient amplitude 
to be bothersome?
 What's the probability that a properly-designed and engineered 
switching power supply will radiate  RF noise of sufficient 
amplitude to be bothersome?
Answer: unknown. likely small but equal.
Kim N5OP
On 1/20/2014 7:13 PM, Ken Brown wrote:
 What is the probability that a transformer/rectifier/capacitor 
filter/linear regulated power supply will generate and radiate 
(through AC power input or DC power output leads) RF noise of 
sufficient amplitude to be bothersome? That probability may not be 
zero.
 What is that probability that a switched mode regulated power 
supply will be not "properly engineered" and generate and radiate 
RF noise of sufficient amplitude to be bothersome?
How do those two probabilities compare?
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
  
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
 
 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
  
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
  
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
 
 |