Re: [TenTec] Corsair II UV EPROM failure

["A R" <raf_3@msn.com>]

Mike,

Thanks! Pulled the P22 plug (schematically labeled "KEY/GND", and the processor 
keyer output is disabled, AND I still have straight key/bug CW capability. I 
can sure live with that.

73!
Allen----W7GIF
  ----- Original Message ----- 
  From: Mike Bryce<mailto:prosolar@sssnet.com> 
  To: Discussion of Ten-Tec Equipment<mailto:tentec@contesting.com> 
  Sent: Wednesday, February 19, 2014 4:02 PM
  Subject: Re: [TenTec] Corsair II UV EPROM failure


  Iam surprised no one mentioned this before 

  Unplug the two wire plug ( that is the output from the microprocessor near 
q3) on the 81246 logic board. 

  Problem solved! 
  Mike wb8vge

  Sent from my iPhone

  > On Feb 19, 2014, at 5:31 PM, Steve Berg 
<wa9jml@frontier.com<mailto:wa9jml@frontier.com>> wrote:
  > 
  > Allen, you do not have to use the internal keyer in the Corsair II. If you 
do, there is a jumper with two RCA phone plugs on it that goes from the keyer 
out connector to the key connector.  I unplug that many times to hook up my bug 
or straight key.  I just plug them into the key jack once the jumper is removed.
  > 
  > 
  _______________________________________________
  TenTec mailing list
  TenTec@contesting.com<mailto:TenTec@contesting.com>
  
http://lists.contesting.com/mailman/listinfo/tentec<http://lists.contesting.com/mailman/listinfo/tentec>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec