Hi Barry, DC connector looks to be factory wired with heat-shrink tubing so
looks OK.
I did check the voltages at that connector and they looked fine, but thanks for
the thought.
Dave K9UX
----- Original Message -----
From: "Barry N1EU" <barry.n1eu@gmail.com>
To: "List, Ten" <tentec@contesting.com>
Sent: Monday, June 16, 2014 8:09:28 AM
Subject: Re: [TenTec] Omni VI Help
Are you sure the dc connector (white 4-pin molex) on the power cable is
properly wired?
Barry N1EU
On Mon, Jun 16, 2014 at 11:02 AM, DAVID <k9ux@comcast.net> wrote:
> Hi everyone. I need some advice on an Omni VI I picked up at an estate
> sale. It's a nice looking rig, loaded with filters, but
> it will not power up. It is shorting the DC voltage to ground it appears.
> Took it to a friend's house and hooked it to an Astron
> 30 amp supply and the voltage dropped to zero!! Darn!!
> So can anybody give me some advice as to what to look for or should I just
> bite the bullet and send it to Ten Tec??
>
> Thanks in advance, Dave K9UX
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|