| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Orion 565 tuning encoder |
| From: | shristov <shristov@ptt.rs> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sun, 22 Jun 2014 04:10:15 +0200 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Barry N1EU <barry.n1eu@gmail.com> wrote: > There's 0.5-0.6V drop between the A9 board and the encoder on the front > panel board. Isn't that excessive? Also, the voltage at the encoder seems > to vary over time 4.3-4.5V. Such a drop is certainly excessive. By providing +5.0 V from an external suuply directly to the encoder you can distinguish between a bad encoder and a bad supply, and then make the repair as needed. 73, Sinisa _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Orion 565 tuning encoder, Bob McGraw - K4TAX |
|---|---|
| Next by Date: | Re: [TenTec] Orion 565 tuning encoder, Barry N1EU |
| Previous by Thread: | Re: [TenTec] Orion 565 tuning encoder, Barry N1EU |
| Next by Thread: | [TenTec] OT: CQ Friedrichshafen Hamfest, Rick - DJ0IP / NJ0IP |
| Indexes: | [Date] [Thread] [Top] [All Lists] |