Re: [TenTec] Invoking OM7 500 Hz filter ?

["Bob McGraw - K4TAX" <RMcGraw@Blomand.net>]

The filter automatically switches with the BW selection. Observe the display 
at the left where you see "IF"  The selected filter is then shown to the 
right of this label.  For this to happen, the MENU selection for I-F FILTER 
must be set to AUTO.
Otherwise one can select the filter of their choice with the selection of 
values at this line.
73
Bob, K4TAX


----- Original Message ----- 
From: <bcarling@cfl.rr.com>
To: <tentec@contesting.com>
Sent: Thursday, July 10, 2014 6:42 PM
Subject: [TenTec] Invoking OM7 500 Hz filter ?


> Hello,
>
> I now have a clean sounding OMNI VII after doing a master reset. Thanks 
> guys.
> Does anyone know how to invoke the 500 Hz Collins filter once it is 
> installed and enabled?
> I have read the manual through twice and still can't figure out how to 
> switch from 2.5 kHz
> filter to 500 Hz !!  Maybe I am not too smart. The book seems to dance all 
> around the topic
> but never tell you how!
>
> 73 - Brian, AF4K
>
> Brian Carling, Radio AF4K
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec