Hi Jim...
I once had a problem with a 2m rig once. I enlisted the assistance of a
local Elmer who had me open it on his work bench, while he looked over
my shoulder and walked me through the process of diagnosis and repair.
I used his scope and test equipment under his supervision.
Maybe you could arrange a similar outing and perform the procedures
suggested by the Guru under similar circumstances. I learned a lot, and
got my rig fixed, with minimal risk I would make it worse on my own.
Maybe you could do that.
=================================== K8JHR ==============
On 7/30/2014 10:15 AM, Jim Allen wrote:
The guru I consulted thought it
should be possible to do the test he proposed and isolate it down to a
handful of parts.
I'm reluctant to go in with a screwdriver/alignment tool and start turning
little devices without proper gear as the circuits interact and doing so
could really mess things up. I have experience at fiddling with something
without knowing what you are doing and without proper equipment. I think
the phrase is "fix it 'til you break it." I have experience at this.
__________________________________________________________
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|