Shawn The ammeter on the
Shawn
The TT PS reads 13-14 A and the meter on the Corsair pegs to the left when
meter switch is at IC. It should swing to the right and read essentially the
same as the meter on the PS. PO is75-77 measured w/ Bird 43.
joe k7mks
----- Original Message -----
From: "shawn via TenTec" <tentec@contesting.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Cc: kb1ckt@yahoo.com
Sent: Saturday, November 7, 2015 5:00:10 PM
Subject: Re: [TenTec] Corsair II Needs TLC
Meter set to swr? Otherwise I wonder if a diode or solder joint open d up and
is not measuring forward power.
what panel meter, the one on the radio or on the power supply? Does the Corsair
read out amps into the radio?
shawn kb1ckt
Sent from my iPad
> On Nov 7, 2015, at 1:23 PM, k7mks@comcast.net wrote:
>
> My recently acquired Corsair II, with DRIVE full CW, delivers 76 watts or so
> on all bands except 10 and 15 where output is slightly less. Panel meter pegs
> to the left and regardless of position of DRIVE it never gets above 0 (zero)
> amperes. Would appreciate your help.
>
> Thanks joe k7mks
>
> pto
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|