I was about to suggest the same thing. N4PY works well with my Orion
and I much prefer it over the manual controls. That said, I THINK the
Orion N4PY program follows changes made by manual controls so you can
mix manual and computer control. Carl...please correct me if I'm wrong
on this as I rarely used it that way.
73 all,
-Lee-
WA3FIY
------ Original Message ------
From: "Carl Moreschi" <n4py3@earthlink.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: 11/11/2015 5:17:43 PM
Subject: Re: [TenTec] orion
Or run my N4PY Orion program which has much more Orion specific
controls in it.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 11/11/2015 3:27 PM, Mike Bryce wrote:
It seems that the ten tec rigs aren't the only ones that suffer this
problem with LCD displays.
Several of the Icom pro versions have display issues. Those displays
are not available anymore either.
Guess you could disconnect the LCD in the Orion and run ham radio
deluxe with the rig on the floor.
Mike wb8vge
Sent from my iPhone
On Nov 11, 2015, at 2:24 PM, denton sprague<denton@oregontrail.net>
wrote:
guess its time to put mine on standby status in the closet and run my
new omni 7.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|