You can do that with my N4PY Orion software by setting a tune power.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 12/21/2015 3:20 PM, denton sprague wrote:
I run an orion with a palstar hf auto that requires only about 1-2 watts of rf drive
to auto tune…
is there an internal pot or setting to tweek from default setting of about 10
watts to 1-2 watts?
I usually back down rf output to about 1-2 watts to get the tuner to fire and i
works fine, but would be nice to leave the power out level set to 100 watts and
have only a couple of watts rf output while in tune mode.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|