1. it is RX only, TX is on ANT1 or ANT2
2. greater than -30 dBm
3. each RX port is -3dB down
73 ES DX,
Gary - AB9M
On 1/5/2016 11:20 AM, demerson wrote:
The Omni VII has a socket for a receive-only antenna, the AUX ANT.
1. Is this socket switched on transmit, or when in use is it
permanently connected to the OMNI VII receiver input?
2. How much stray RF power can be allowed to reach this socket during
OMNI VII transmit? More than 10 dBm?
3. If the N4PY mod cables are installed, to allow use of a 2nd
receiver, does that affect the answers?
Unfortunately the simplified block diagram in the Omni VII manual
doesn't show enough detail to answer these questions.
Thanks,
73
Darrel, aa7fv
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|