I can’t speak insider facts here but I have had many Paragon 2 radios and none
of them had PLL issues.
Gary
> On Jan 19, 2016, at 5:17 PM, steve jobes via TenTec <tentec@contesting.com>
> wrote:
>
> I have not had any problems with my paragon 2, and can't recall hearing of
> any issues with them.
>
> 73,
> Steve W1DXH
>
>
>
>
>
>
>
> -----Original Message-----
> From: k7mks <k7mks@comcast.net>
> To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> Sent: Tue, Jan 19, 2016 6:14 pm
> Subject: [TenTec] Paragon vs Paragon II - PLL
>
> Did Ten Tec make any performance improvements (ie soldered board conections,
> etc) in the later #586 PLL over the earlier #585 PLL's ?
>
> Thank you. joe k7mks
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|