Gary: Your friendly TenTec parts supplier in Myrtle Beach has one. It came in
error.I was wanting the large cap knob. If your knob is split where it
contacts the shaft, thereis a fix. You need a small wire from one of the ties
that are on the end of a loaf of breadand tightly wrap and tie it in the recess
of the knob. Then fill that recess with epoxy andthe knob is good to go and
better than new. The knob maker was trying to save a pennyon the knobs by
leaving that material out and therefore making the knob prone to breakage.I
have used that fix on several TenTec knobs and have not had a failure.
I'll sell you a new knob if that's what you want. Can't remember what they
cost but ...I have your address and can get it out.
Clayton N4EV
From: "Gary H. Harmon, Jr." <gharmon@idworld.net>
To: TEN-TEC List <tentec@contesting.com>; ten_tec_radio_net@yahoogroups.com
Sent: Saturday, March 12, 2016 11:02 AM
Subject: [TenTec] Knob for 229A Tuner
Does anyone have any extra Ten Tec knobs? I need one for the bypass switch.
Appreciate any help.
73,
Gary H. Harmon, Jr. - K5JWK - HAM Radio and ATARI Archaeologist
6003 Archwood
San Antonio, TX 78239-1504
210.657.1549 h / 210.884.6926 c/t
210.657.1549 fax with prior notification
gharmon@idworld.net
"Too many projects - Not enough time!"
"Retirement = Every day is a Saturday except Sunday"
http://www.grissomroadcoc.org
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|