Re: [TenTec] Omni V Relays

[Joe Papworth via TenTec <tentec@contesting.com>]

Hi Lee,
I wonder if it's similar to the Omni 6.
There's a procedure I wrote for doing it on the Omni 6 Plus that Barry stored 
somewhere in his wiki pages.
 If u can't find it, let me know. I'm sure I still have the file somewhere.

Later, Joe, K8MP

Sent from AOL Mobile Mail


-----Original Message-----
From: Bryan Lee Cornwell <blcornwell@k2blc.com>
To: Ten-Tec mailing list <tentec@contesting.com>
Sent: Mon, Jul 18, 2016 04:39 PM
Subject: [TenTec] Omni V Relays


Has anyone replaced the relays on the low pass filter board on the Omni 
V ?.  I've found some posts on the reflector referencing Paragon 
replacements. Are they the same?

I need at least 5 and I may replace all of them while I have the board out.

Thanks in advance

Lee K2BLC


-- 
Bryan Lee Cornwell

<a href="mailto:blcornwell@k2blc.com";>blcornwell@k2blc.com</a>

<a href="http://k2blc.com"; target="_blank">http://k2blc.com</a>

_______________________________________________
TenTec mailing list
<a href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a>
<a href="http://lists.contesting.com/mailman/listinfo/tentec"; 
target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec