| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] TenTec sheet metal |
| From: | Stuart Rohre <Rohre@arlut.utexas.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 03 Jun 2017 16:51:44 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
I think Ten Tec's previous owners a couple of regimes back; discontinued
enclosure manufacture. Don't know if last rigs were done in house or
shopped out to contractor. (It was announced on this reflector.)
Stuart Rohre K5KVH _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] [] Running a Century 21 on external 12V power, Stuart Rohre |
|---|---|
| Next by Date: | Re: [TenTec] [] Running a Century 21 on external 12V power, Gary F |
| Previous by Thread: | Re: [TenTec] TenTec sheet metal, Mike Bryce |
| Next by Thread: | [TenTec] An Unusual Argosy 525D, Ron Notarius W3WN |
| Indexes: | [Date] [Thread] [Top] [All Lists] |