PS- Radio Shack used to stock the 25 amp version in their stores. Some of them
may still have it.
Sent from AOL Mobile Mail
-----Original Message-----
From: Joe Papworth via TenTec <tentec@contesting.com>
To: tentec <tentec@contesting.com>
Cc: k8mp <k8mp@aol.com>
Sent: Tue, Jun 27, 2017 02:09 PM
Subject: Re: [TenTec] 962 power supply {was 961 PWR Supply}
It was a long time ago but it was probably the only place I found room. Or it
could have been an existing screw or stud.
That bridge is toast.
Sent from AOL Mobile Mail
-----Original Message-----
From: Robert S Jenkins <<a href="mailto:qrp@kg4kgl.net";>qrp@kg4kgl.net</a>>
To: Discussion of Ten-Tec Equipment <<a
href="mailto:tentec@contesting.com";>tentec@contesting.com</a>>
Sent: Tue, Jun 27, 2017 01:31 PM
Subject: Re: [TenTec] 962 power supply {was 961 PWR Supply}
Those values were with the bridge completely out of the circuit.
Why did you mount it on the back of the front panel?
Tnx,
Robert
KG4KGL
> On Jun 27, 2017, at 13:25, Joe Papworth via TenTec <<a href="<a
> href="mailto:tentec@contesting.com";>tentec@contesting.com</a?">mailto:tentec@contesting.com";>tentec@contesting.com</a</a>>>
> wrote:
>
> If the bridge is still in the circuit, that .2 ohm reading is the secondary
> winding of the transformer.
> If it does end up being the bridge, I recommend you remotely mount the new
> one somewhere. I put mine on the back side of the front panel. Use BIG wire.
> (At least 12 gauge)
> And use heat sink grease.
>
> Sent from AOL Mobile Mail
>
_______________________________________________
TenTec mailing list
<a href="<a
href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a?">mailto:TenTec@contesting.com";>TenTec@contesting.com</a</a>>
<a href="<a href="http://lists.contesting.com/mailman/listinfo/tentec";
target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>"
target="_blank"><a
href="http://lists.contesting.com/mailman/listinfo/tentec</a"
target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a</a>>
_______________________________________________
TenTec mailing list
<a href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a>
<a href="http://lists.contesting.com/mailman/listinfo/tentec";
target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|