[TenTec] Winlink and Winmoor on an Omni 6 Plus

[Joe Papworth via TenTec <tentec@contesting.com>]

Gents,
Winmoor does not support the Omni 6 Plus in their Rig Control software.
I'm thinking that someone once told me there was a different brand and model 
that used a command set equal to or very similar to the Omni 6.
Does that ring any bells?

Or, has anyone found another work-around for this problem?

Thanks, Joe, K8MP



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec