Hi Stan,
I'm keying the rig through the serial port when using MMTTY and FLDigi. I was
hoping to do the same with WinLink/Winmor.
Lee has it working so I just need to find out what he's doing right and what
I'm doing wrong HI HI
Joe, K8MP
-----Original Message-----
From: Stan Gammons <s_gammons@charter.net>
To: tentec <tentec@contesting.com>
Sent: Sun, Mar 4, 2018 9:57 am
Subject: Re: [TenTec] I surrender
Are you using PTT to key the rig with fldigi? With WSJT-X, I've tried using
CAT with my Omni VI and I can't get it to work right. It will key the rig when
I select "test CAT" but it won't unkey until I close the program. Maybe
Winlink is trying to use CAT and should be using PTT? I use the default CIV
address of 04, 19200 for the baud rate and a home made computer interface which
key the rig when RTS goes high. hth 73 Stan KM4HQE
href="http://lists.contesting.com/mailman/listinfo/tentec";
target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a> >> > >>
_______________________________________________ >> TenTec mailing list >> <a
href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a> <<a
href="mailto:TenTec@contesting.com?";>mailto:TenTec@contesting.com</a>> >> <a
href="http://lists.contesting.com/mailman/listinfo/tentec";
target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a> >
_______________________________________________ > TenTec mailing list >
TenTec@contesting.com > http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________ TenTec mailing list
TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|