| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Need RF choke |
| From: | Gary Hendricks <k4mt1950@charter.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Tue, 29 May 2018 16:43:52 -0400 |
| List-post: | <mailto:tentec@contesting.com> |
I am working on another tentec omni VI and I have a bad RF choke in the
collector circuit for the pre driver. Manual says 100 so I assume 100
Uh but cant seem to locate a sub that is higher than 6 MHz. Its one of
those very small ferrite core chokes used in several places on low level
driver.
Anyone know where I can find a couple? Even talked to coilcraft engineer and they dont have anything Gary K4MT _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Omni VI Logic board layout error, Gary Hendricks |
|---|---|
| Next by Date: | Re: [TenTec] Need RF choke, MadScientist1948 |
| Previous by Thread: | [TenTec] Omni VI Logic board layout error, Gary Hendricks |
| Next by Thread: | Re: [TenTec] Need RF choke, MadScientist1948 |
| Indexes: | [Date] [Thread] [Top] [All Lists] |