Once you have the top and bottom covers off, remove the top screw on
each side of the front panel. The front panel will tilt forward for
access to the encoder.
73
Bob, K4TAX
On 8/8/2018 4:14 AM, Steve Hunt wrote:
Folks,
I need to replace the rotary encoder in my OmniVI. Can anyone tell me
the easiest way to get at it and do the replacement. It's easy to spot
the encoder when you take the bottom cover off, but I wonder it you
then need to fully remove the front panel, and if so how big a job it is?
Steve G3TXQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|