Fine on your test equipment and work in audio. But have you actually measured
the performance of the Tentec Argonaut VI receiver? I have. My audio
experience is rather extensive. With 14 years as a recording engineer with
CBS Records and 15 years in tech support with SONY Pro Audio and teaching
Studio Electronics at Belmont college......just to mention a few. I'm by no
means a novice in the audio field.
Bob, K4TAX
Sent from my iPhone
On Aug 20, 2018, at 12:20 PM, Paul Christensen <w9ac@arrl.net> wrote:
>> "Have you heard, observed or measured the artifacts of this receiver? If
> not, you have no clue as to the minuscule magnitude of the issue."
>
> Thanks Bob, but I think I have a clue. People who actually know me (and my
> background) also think I have a clue. I regularly use high-end audio test
> equipment in my noise, level, and distortion measurements. Audio test
> equipment includes a Tektronix AA-501A analyzer with an ultra-low-distortion
> SG-505 module. The Tek equipment is visible on the operating desk as shown
> on my QRZ.com page. I also use SpectraPlus software with a pro-grade sound
> card.
>
> I stand by my prior comments.
>
> Paul, W9AC
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|