Hi Petr,
This is the list of changes for the Orion II (566) firmware, Version
V3.033xe:
2015-12-22Version V3.033xe
==============================================
For this release, it is necessary to do the full Master Reset/RAM Clear
sequence after the
firmware is updated.
1. Download the new installer update file, which will force a Master Reset.
2. Power Down radio.
3. Perform a Master Reset.
4. Power Down radio.
5. Perform a RAM Clear.
6. Power Down radio.
7. Perform a Master Reset.
8. Power Down radio.
9. Power Up radio, and ready to use.
Changes include:
These changes apply to the Main Rx only. The Sub Rx was not changed.
1-Added selection of S-Meter input to Other Menu. Selection is AGC Level
or RF Signal.
Default is AGC Level. AGC Level means the S-meter will not go lower than
the AGC
Threshold/Knee; RF Signal means that the S-Meter indicates the signal
strength at the antenna,
regardless of current AGC threshold or action. Selection is retained
over power cycles.
2-S-meter reading is compensated for ATTN setting, Preamp setting,
signal reduction caused by
the analog hardware AGC with strong (> S-9+35) signals, and the RF Gain
control.
3-S-meter is calibrated so S-9 is 50 uV across 50 Ohms at the antenna
terminals.
4-S-meter calibration routine updated to correct for a missing step in
the table.
5-S-meter ballistics follow the Hang Time and Decay Rate of currently
selected AGC profile.
Other changes:
6-Forced NOTCH to always be OFF after a power cycle.This fixed the
problem with the DSPs crashing if both NB and NOTCH were enabled during
a power cycle.
7-Fixed Serial Command *BS+1
If you get the update and install it, there will be a file named
566History.pdf which contains the changes for all versions.
73..
Howard, WA9AXQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|