TenTec
[Top] [All Lists]

Re: [TenTec] ARGOSY 2

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] ARGOSY 2
From: Mike Bryce <prosolar@sssnet.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 16 Sep 2020 13:33:08 -0400
List-post: <mailto:tentec@contesting.com>
If you don’t have a ‘scope, a RF probe would be the next best thing. Lacking, 
that a short hunk of wire into a second receiver should sniff enough rf that 
you should be able to hear any increase in signal.

But that being said, probe the base of the finals/drivers and see if there is 
RF 
Is the PA drawing current but no RF?
You do have the Drive up all the way? 

Make sure you have the “T” voltages and bias to the PA


Mike, WB8VGE
SunLight Energy Systems
The Heathkit Shop
http://www.theheathkitshop.com/
J e e p
o|||||||o 

A man with one clock knows what time it is. A man with two clocks is never sure.

> 
>> 
>> Hi all
>> 
>> Some progress on the above radio, voltages are very close to what the
>> manual states, but still no TX.
>> 
>> What should i see from the mixer board RF connector, i dont appear to
>> see output drive on my Fluke meter feeding the RF amp?.
>> 
>> Found a leaky cap on the control board, all changed for the next range
>> higher working and 105 degree working types.
>> 
>> Also found a mini relay 'hot melt glued' to a board, this had 2 x TX
>> voltages wires (yellow) attached, or should have been, the soldering had
>> not been done and the wires had broken free from the pins on the relay,
>> the control wire was also soldered to the TX line, so cant see what it
>> was supposed to do, i removed it and re-instated the wires correctly,
>> unfortunately that didn't help the lack of TX.
>> 
>> thanks to all for comments so far, keep them coming please.
>> 
>> thanks
>> 
>> 73
>> 
>> Snowy G0HZE
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>