Hi Snowy,
Did you read this:
https://tentecwiki.eqth.net/doku.php?id=dialrestring
Cheers
Martin, HS0ZED
Sent from my iPad
> On 4 Apr 2021, at 15:28, ROLAND HOWELL via TenTec <tentec@contesting.com>
> wrote:
>
>
> Good Afternoon Gents, a Happy Easter to you all
> I have corrected the rebuild error on the Argonaut 515, i copied my
> instructions on the disassembly but the P/O had rebuilt it incorrectly, so i
> just copied the error.
> With the aid of a diagram from some learned chaps on the TT reflector i have
> it now performing correctly.
>
> now i have a problem with the restringing of the dial cord, got it almost
> correct but the pointer continues its travel over the 'S' meter, it stops at
> the other end ok, so have i rebuilt it correctly or is there something that i
> need to do, it has about 5 x turns on the PTO shaft.
>
> So once again i am asking for help and advice, a drawing would be nice if at
> all possible or the location of said drawing
>
> thanking you in anticipation
>
> 73
> Snowy G0HZE
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|