I have a Ten Tec Model 538 Jupiter and a Model 963 power supply I bought new
in2001. I am running Firmware Version1.28. It is not connected to an
amplifier.
I was in a CW QSO,not using the internal keyer, when thetransmitter turned on
continuously. Thekey had no effect. I pulled the key plug – no change. The
mike was not connected.
I switched modes. CW,FM, and AM – transmits continuously. USBand LSB switches
to transmit (“P” = 0); no RF output. This is consistent on all bands.
I did a RESET several times. It showed a RESET and received WWV. When I went
to the CW mode it showed the same continuous transmit problem. Behavior did
not change after RESET.
Suggestions would be welcomed.
73
Mac
WQ8U
Hillsborough, NC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|