Hi Robert
From HIFI SSB here in the UK, he doesn't have another, a few other bits
but not the push button pcb or the logic board.
regards
Snowy G0HZE
------ Original Message ------
From: "Dry Martini Holding Company" <qrp@kg4kgl.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, 3 Nov, 23 At 16:08
Subject: Re: [TenTec] OMNI V
Who did you get the board from? I would like another PLC board for my
Omni V.
Robert
KG4KGL
Sent from my iPhone
On Nov 3, 2023, at 09:01, ROLAND HOWELL via TenTec
<tentec@contesting.com> wrote:
Hi All
An update on the Omni v, i was lucky enough to get a 81457 pcb from a
'parted' out radio, that cured the no audio problem, also found a
trapped wire on the PA section, terminal 1, the white wire, pos volts to
the relay i believe, cut, soldered and heat shrunk it, sorted.
BUT i still have the button problem, now gravitating towards the
ULN5818A serial interface, wondering if the shorted wire has corrupted
something on the logic board.
Unless you can advise otherwise!
Cheers and beers
Snowy
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<http://lists.contesting.com/mailman/listinfo/tentec>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<http://lists.contesting.com/mailman/listinfo/tentec>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|