Topband
[Top] [All Lists]

Topband: Phased 2-wire Beverage antennas

To: <topband@contesting.com>
Subject: Topband: Phased 2-wire Beverage antennas
From: i4jmy@iol.it (Maurizio Panicara)
Date: Fri, 03 Jan 2003 05:39:22 -0500
With such an arrangement I think that one could try to play with phases to
electrically steer heading, and consequently nulls.
This obviously is limited to reasonable small amounts.

73,
Mauri I4JMY


----- Original Message -----
From: "Tom Rauch (by way of btippett@alum.mit.edu)" <w8ji@contesting.com>
To: <Topband@contesting.com>
Sent: Thursday, January 02, 2003 1:41 PM
Subject: Re: Topband: Phased 2-wire Beverage antennas


 >
 >  > Got a question about the two-wire Beverage antennas....
 >  >
 >  > Assuming that:
 >  > 1. Two identical 2-wire Beverages, separated by, say 270 feet...
 >  >> 5. The coax is matched to the connected loads... 6. Both antennas
 > are
 >  > being operated in the "PUSH-PULL" mode...
 >  >     receiving from the "back" or "near" direction of the antenna....
 >
 > Yes, it makes a difference! That would put one of the antenna out-of-
 > phase!
 >
 > You must have the phase identical in the back-fire mode.
 >
 > Also, each antenna must have similar or ideally the same phase delay
 > along the antenna wires.
 >
 > 73, Tom W8JI
 > W8JI@contesting.com


<Prev in Thread] Current Thread [Next in Thread>