Topband
[Top] [All Lists]

Re: Topband: New install being put together

To: "TopBand List" <topband@contesting.com>
Subject: Re: Topband: New install being put together
From: "Jim Brown" <jim@audiosystemsgroup.com>
Date: Wed, 18 Mar 2009 15:10:51 -0700
List-post: <topband@contesting.com">mailto:topband@contesting.com>
On Wed, 18 Mar 2009 15:16:58 -0400, George \(K8GG\) & Marijke Guerin wrote:

>There will be essentially zero losses in hard line from your shack to the 
>vertical antenna. 

And depending on how long the line is, quite small losses in RG8 on 160M. 
37 ohms is quite close to 50 ohms, there will be at least a few ohms of 
resistance in the radials, so additional losses due to SWR are miniscule. 
Unless the feedline is really long (more than a few hundred feet) I'd go 
with RG8 that has solid copper center and a good braid shield. You do plan 
to stick with legal power, don't you? 

>I would use the L-network at the shack, as it is easiest to adjust 
>if you have a good roller inductor and capacitor to build an L-net tuner,
>or use the TenTec 229 or 238 tuners.

Yes. The TenTec tuners will do very well with this antenna. Heck -- the 
output network in my Titan 425 loads my 86 ft vertical directly over at 
least half of 160M without a tuner, and the tuners do just fine with the 
rest of the band for SSB contests! And your antenna, being much thicker 
than my wire, will have signficantly greater SWR bandwidth. 

73,

Jim K9YC


_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband

<Prev in Thread] Current Thread [Next in Thread>