For monoband use, use an asynchronous transformer to go to 50 Ohms if you or
the equipment is that fussy.
http://www.k1ttt.net/technote/matching.html
Carl
KM1H
----- Original Message -----
From: <donovanf@starpower.net>
To: <topband@contesting.com>
Cc: <jim@audiosystemsgroup.com>
Sent: Friday, June 13, 2014 4:01 PM
Subject: Re: Topband: 50 ohm direct burial coax cable
You can easily make the 75 ohm coax essentially "invisible" in a monoband
application by using some RG-11 to extend the total length of the 75
ohm feedline to any multiple of 1/2 wavelength.
73
Frank
W3LPL
----- Original Message -----
From: "Jim Brown" <jim@audiosystemsgroup.com>
To: topband@contesting.com
Sent: Friday, June 13, 2014 8:33:35 PM
Subject: Re: Topband: 50 ohm direct burial coax cable
On 6/13/2014 12:17 PM, Donald Chester wrote:
I think you're being overly picky. The 75-ohm cable would be at worst a
1.5:1 mismatch. Probably a fraction of a dB loss at most, particularly
with foam type hard line. If you have a source of good, low-loss 75-ohm
coax that will safely handle the power you intend to run, and which will
hold up for an extended period under direct burial, use it.
Yes. Assuming a suitable matching network at the transmitter, worst case
excess loss due to a 1.5:1 mismatch is 0.18 dB, no matter how long the
line. Curves showing this have been in every edition of the ARRL
Handbook since I've been a ham (59 years).
73, Jim K9YC
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|