Re: Topband: High Pass Filter

["m.r.c." <mrc02@kinderteacher.com>]

It is shown with RCA connectors.  Is it available with
F?
BNC?
I have generally found RCA connectors to be unsatisfactory in the long term for a variety 
of reasons generally revolving around the "Astro" plate hard nickel surfaces.  A large 
number of 160 receive antenna systems are built with type F connectors with generally good 
results - as well as it being a threaded connector instead of a slip on (read: slip off in 
the middle of the contest)
thanks

Robin WA6CDR

---- Original Message ----- 
From: "Jay Terleski" <jayt@arraysolutions.com>
To: <topband@contesting.com>
Sent: Monday, October 12, 2015 09:03
Subject: Topband: High Pass Filter


> "Where can I find a schematic for a good high pass filter that rolls off at
> 1700 kHz?"
>
> Hopefully with permission of the moderator I suggest you might look at our
> inexpensive filters.  The specs are good even at 1.7 MHz
> http://arraysolutions.com/Products/AS160HPF.htm
>
> Jay Terleski
> President
> Array Solutions
> 214 954 7140
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband 
_________________
Topband Reflector Archives - http://www.contesting.com/_topband