Topband
[Top] [All Lists]

Re: Topband: RBOG installation

To: <topband@contesting.com>
Subject: Re: Topband: RBOG installation
From: "David Harmon" <k6xyz@sbcglobal.net>
Date: Tue, 25 Apr 2017 14:24:15 -0500
List-post: <topband@contesting.com">mailto:topband@contesting.com>
I cut the grass closely then used DXE radial wire and DXE staples to hold
down the wire to the surface.
No need to bury the radials as the grass will grow over in a few months
especially of you do it now just before the growing season. 
I did 90 radials this way and ain't seen them since!
I use a Kubota tractor style mower and have not cut a wire yet.
One thing....pull the radial out and put the first staple near the end.
Align the staples so that they are not 90 degrees to the radial....align the
staple WITH the radial so that the staple has maximum contact with the wire.
The DXE wire does not snarl coming off the reel....couldn't have been
easier.
I stuck a large screwdriver through the reel and then into the ground.
Then I measured and cut all 90 radials and then laid them out...
It's all been out there now for 10 years and the antenna still measures at
the base as I installed it.

73

David Harmon
K6XYZ
Sperry, OK

-----Original Message-----
From: Topband [mailto:topband-bounces@contesting.com] On Behalf Of Brian
Pease
Sent: Tuesday, April 25, 2017 1:18 PM
To: topband@contesting.com
Subject: Re: Topband: RBOG installation

Google "garden staples ebay".  $11.50/100 free shipping.

On 4/25/2017 12:54 PM, James Denneny wrote:
> My garden tractor lawn mower ate one of my RBOG's.  I thought 2.5 inch 
> blade height was sufficient but the updraft from the mower deck lifted 
> the wire into the blade.
>
>   
>
> Yes, I can raise blade cut to 3 inches.  I prefer a closer cut for
neatness.
> However, I am contemplating pinning the wire with DXE ground staples 
> every 5 to 10 ft versus burying the wire an inch into the soil.  I am 
> concerned the latter approach might defeat signal reception.
>
>   
>
> Comments?
>
>   
>
> Jim K7EG
>
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
>

_________________
Topband Reflector Archives - http://www.contesting.com/_topband

_________________
Topband Reflector Archives - http://www.contesting.com/_topband

<Prev in Thread] Current Thread [Next in Thread>